A commitment to innovation and sustainability

Below is the brains of my motion simulator it has an Intel 11th generation i9 microprocessor and 64 gigs of memory as well as Nvidia 3090Ti gpu. The sound Sony 150 watt per channel amp with Dolby Atmos and currently 4 speakers and 5 speakers soon will add the center channel. The speakers are mounted on the actuators with custom 3D printed mounts on my servos that I designed. I also have done all the wiring in this box as well 3D printed the custom mounts and mounted the drivers and controller on a carbon fiber panel I cut to fit inside of the cabinet. The 1500 watt amp on the top is a Buttkicker setup to power the rear enclosed voice coil that vibrates the extruded aluminum during conditions such as road surfaces. Pretty much designed everything the actuators, speaker mounts, custom mounting brackets and the monitor mount.

One of the products I worked on years ago. It was a duel 128 bit bus disk controller board with two 32 bit redundant motorola microprocessors. Set up to offer backup if one side failed.